This is how you should utilize two previous belts to hold up a cool DIY shelf

When you have two previous leather-based belts that you do not put on any extra or that do not fairly match, strive utilizing them to hold up a shelf. It is simpler than it sounds.

In keeping with Cologne’s DIY Academy, all you want so as to flip a few previous equipment into eye-catching ornament are: Two leather-based belts a couple of metre lengthy and an appropriate piece of wooden. A good selection is a plywood shelf (medium density; MDF) about 85cm vast, 25cm deep and 2cm excessive.

In your toolbox you will additionally want two screws with matching wall plugs, and 4 quick screws. You will additionally wish to have a carpet knife, a screwdriver, a drill, a ruler, a spirit degree and a pencil useful.

Take the belt and on the facet with out the buckle, make a straight lower about 1.5cm to the appropriate of the primary gap.

Then measure about 87cm to the left and lower each belts there as nicely, to take away the buckles.

Right here from this finish, although, you will want to make a gap utilizing the drill. Make it in the midst of the belt, on the identical distance as on the different finish.

Subsequent, measure 10cm from the 2 ends of the shelf in the direction of the center, and mark it utilizing the pencil. It will present the place to drill the holes within the wall.

Now go to the wall and mark the drill holes on the peak you need for the shelf. Keep in mind that the belts will cling from this gap so your shelf will cling down decrease under.

Then drill two holes into the wall and put the wall plugs in. Then create a loop with the belt so the holes at every finish of it are on prime of one another. Now, screw it into the wall.

Repeat the method with the opposite belt, then put the shelf within the center, and use two screws to repair the underside to every belt. – dpa

Leave a Reply